← Back to Parts Catalog

Genuine Buddy 125 - Ignition Coil

When performing maintenance on your Genuine Buddy 125, relying on accurate engineering data is critical. Below you will find the complete OEM specifications, torque settings, and installation requirements for the Ignition Coil.

Engineering Specifications Table

OEM Part Number13000-PNA-000
Component NameIgnition Coil
Brand / Model FitmentGenuine Buddy 125
Dimensions / SizingStandard 2-wire with boot
Torque SpecsMounting bolts: 9 Nm
Fluid / Electrical SpecsPrimary resistance: 0.2-1.2 Ω
Cross-CompatibilityPGO Blur 150

Installation & Torque Warning

Improper installation of the Ignition Coil can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of Mounting bolts: 9 Nm for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Genuine Buddy 125, verify that you are installing a genuine part matching OEM number 13000-PNA-000. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Ignition Coil on my Genuine Buddy 125?
Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.
2. Can I use a generic replacement instead of the OEM 13000-PNA-000?
Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (Standard 2-wire with boot) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.
3. What is the most common mistake when installing this part?
The most frequent error is ignoring the factory torque specifications. Failing to apply the required Mounting bolts: 9 Nm disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.