← Back to Parts Catalog

Honda ADV 150 - Front Brake Rotor (Disc)

When performing maintenance on your Honda ADV 150, relying on accurate engineering data is critical. Below you will find the complete OEM specifications, torque settings, and installation requirements for the Front Brake Rotor (Disc).

Engineering Specifications Table

OEM Part Number45351-K0W-N01
Component NameFront Brake Rotor (Disc)
Brand / Model FitmentHonda ADV 150
Dimensions / Sizing240mm diameter, 3.5mm min thickness
Torque SpecsRotor bolts: 42 Nm (31 lbf·ft)
Fluid / Electrical SpecsN/A
Cross-CompatibilityHonda PCX 150 (ABS models)

Installation & Torque Warning

Improper installation of the Front Brake Rotor (Disc) can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of Rotor bolts: 42 Nm (31 lbf·ft) for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Honda ADV 150, verify that you are installing a genuine part matching OEM number 45351-K0W-N01. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Front Brake Rotor (Disc) on my Honda ADV 150?
Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.
2. Can I use a generic replacement instead of the OEM 45351-K0W-N01?
Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (240mm diameter, 3.5mm min thickness) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.
3. What is the most common mistake when installing this part?
The most frequent error is ignoring the factory torque specifications. Failing to apply the required Rotor bolts: 42 Nm (31 lbf·ft) disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.