Honda ADV 150 Rear Shock Absorber Specs & Torque (OEM: 52400-K0W-N01)

Engineering Specifications Table

OEM Part Number	52400-K0W-N01
Component Name	Rear Shock Absorber
Brand / Model Fitment	Honda ADV 150
Dimensions / Sizing	Eye-to-eye length: 395 mm
Torque Specs	Upper/Lower bolts: 39 Nm
Fluid / Electrical Specs	Nitrogen/oil sealed
Cross-Compatibility	Unique to ADV 150

Installation & Torque Warning

Improper installation of the Rear Shock Absorber can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of Upper/Lower bolts: 39 Nm for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Honda ADV 150, verify that you are installing a genuine part matching OEM number 52400-K0W-N01. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Rear Shock Absorber on my Honda ADV 150?

Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.

2. Can I use a generic replacement instead of the OEM 52400-K0W-N01?

Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (Eye-to-eye length: 395 mm) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.

3. What is the most common mistake when installing this part?

The most frequent error is ignoring the factory torque specifications. Failing to apply the required Upper/Lower bolts: 39 Nm disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.