Honda Grom 125 Centrifugal Oil Filter Cover Specs & Torque (OEM: 15431-K26-900)

Engineering Specifications Table

OEM Part Number	15431-K26-900
Component Name	Centrifugal Oil Filter Cover
Brand / Model Fitment	Honda Grom 125
Dimensions / Sizing	OEM aluminum cover
Torque Specs	Screws: 5 Nm (3.6 lbf·ft)
Fluid / Electrical Specs	Clean out every 7,500 miles
Cross-Compatibility	Honda Monkey 125

Installation & Torque Warning

Improper installation of the Centrifugal Oil Filter Cover can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of Screws: 5 Nm (3.6 lbf·ft) for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Honda Grom 125, verify that you are installing a genuine part matching OEM number 15431-K26-900. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Centrifugal Oil Filter Cover on my Honda Grom 125?

Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.

2. Can I use a generic replacement instead of the OEM 15431-K26-900?

Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (OEM aluminum cover) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.

3. What is the most common mistake when installing this part?

The most frequent error is ignoring the factory torque specifications. Failing to apply the required Screws: 5 Nm (3.6 lbf·ft) disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.