Honda PCX 150 Spark Plug Specs & Torque (OEM: 31917-KPH-901)

Engineering Specifications Table

OEM Part Number	31917-KPH-901
Component Name	Spark Plug
Brand / Model Fitment	Honda PCX 150
Dimensions / Sizing	10mm thread, 19mm reach
Torque Specs	16 Nm (12 lbf·ft)
Fluid / Electrical Specs	Gap: 0.8-0.9mm
Cross-Compatibility	Honda SH150i

Installation & Torque Warning

Improper installation of the Spark Plug can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of 16 Nm (12 lbf·ft) for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Honda PCX 150, verify that you are installing a genuine part matching OEM number 31917-KPH-901. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Spark Plug on my Honda PCX 150?

Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.

2. Can I use a generic replacement instead of the OEM 31917-KPH-901?

Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (10mm thread, 19mm reach) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.

3. What is the most common mistake when installing this part?

The most frequent error is ignoring the factory torque specifications. Failing to apply the required 16 Nm (12 lbf·ft) disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.