← Back to Parts Catalog

Kymco Like 150i (ABS) - Air Filter Element

When performing maintenance on your Kymco Like 150i (ABS), relying on accurate engineering data is critical. Below you will find the complete OEM specifications, torque settings, and installation requirements for the Air Filter Element.

Engineering Specifications Table

OEM Part Number17211-LGR4-E00
Component NameAir Filter Element
Brand / Model FitmentKymco Like 150i (ABS)
Dimensions / SizingPleated paper filter
Torque SpecsCover screws: 1.5 Nm
Fluid / Electrical SpecsN/A
Cross-CompatibilityUnique to Like 150i 4-valve engine

Installation & Torque Warning

Improper installation of the Air Filter Element can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of Cover screws: 1.5 Nm for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Kymco Like 150i (ABS), verify that you are installing a genuine part matching OEM number 17211-LGR4-E00. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Air Filter Element on my Kymco Like 150i (ABS)?
Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.
2. Can I use a generic replacement instead of the OEM 17211-LGR4-E00?
Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (Pleated paper filter) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.
3. What is the most common mistake when installing this part?
The most frequent error is ignoring the factory torque specifications. Failing to apply the required Cover screws: 1.5 Nm disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.