Suzuki Burgman 400 Spark Plug Specs & Torque (OEM: NGK CR7E)

Engineering Specifications Table

OEM Part Number	NGK CR7E
Component Name	Spark Plug
Brand / Model Fitment	Suzuki Burgman 400
Dimensions / Sizing	10mm thread, 19mm reach
Torque Specs	11 Nm (8 lbf·ft)
Fluid / Electrical Specs	Gap: 0.7-0.8mm
Cross-Compatibility	Many Suzuki ATVs/Scooters

Installation & Torque Warning

Improper installation of the Spark Plug can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of 11 Nm (8 lbf·ft) for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Suzuki Burgman 400, verify that you are installing a genuine part matching OEM number NGK CR7E. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Spark Plug on my Suzuki Burgman 400?

Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.

2. Can I use a generic replacement instead of the OEM NGK CR7E?

Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (10mm thread, 19mm reach) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.

3. What is the most common mistake when installing this part?

The most frequent error is ignoring the factory torque specifications. Failing to apply the required 11 Nm (8 lbf·ft) disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.