Vespa GTS 300 Engine Oil Filter Specs & Torque (OEM: 82635R)

Engineering Specifications Table

OEM Part Number	82635R
Component Name	Engine Oil Filter
Brand / Model Fitment	Vespa GTS 300
Dimensions / Sizing	OD: 52 mm, Thread: M14 x 1.5
Torque Specs	Filter cartridge: 12-16 Nm
Fluid / Electrical Specs	5W-40 Synthetic Engine Oil
Cross-Compatibility	Piaggio Beverly 300

Installation & Torque Warning

Improper installation of the Engine Oil Filter can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of Filter cartridge: 12-16 Nm for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Vespa GTS 300, verify that you are installing a genuine part matching OEM number 82635R. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Engine Oil Filter on my Vespa GTS 300?

Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.

2. Can I use a generic replacement instead of the OEM 82635R?

Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (OD: 52 mm, Thread: M14 x 1.5) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.

3. What is the most common mistake when installing this part?

The most frequent error is ignoring the factory torque specifications. Failing to apply the required Filter cartridge: 12-16 Nm disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.