← Back to Parts Catalog

Vespa Sprint 150 (i-Get) - Air Filter Element

When performing maintenance on your Vespa Sprint 150 (i-Get), relying on accurate engineering data is critical. Below you will find the complete OEM specifications, torque settings, and installation requirements for the Air Filter Element.

Engineering Specifications Table

OEM Part NumberB018070
Component NameAir Filter Element
Brand / Model FitmentVespa Sprint 150 (i-Get)
Dimensions / SizingFoam pad element
Torque SpecsAirbox screws: 1.5 Nm
Fluid / Electrical SpecsWashable, requires light oiling
Cross-CompatibilityVespa Primavera 150 (i-Get)

Installation & Torque Warning

Improper installation of the Air Filter Element can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of Airbox screws: 1.5 Nm for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Vespa Sprint 150 (i-Get), verify that you are installing a genuine part matching OEM number B018070. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the Air Filter Element on my Vespa Sprint 150 (i-Get)?
Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.
2. Can I use a generic replacement instead of the OEM B018070?
Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (Foam pad element) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.
3. What is the most common mistake when installing this part?
The most frequent error is ignoring the factory torque specifications. Failing to apply the required Airbox screws: 1.5 Nm disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.