← Back to Parts Catalog

Yamaha Vino Classic 50 - AGM Battery (12V 4Ah)

When performing maintenance on your Yamaha Vino Classic 50, relying on accurate engineering data is critical. Below you will find the complete OEM specifications, torque settings, and installation requirements for the AGM Battery (12V 4Ah).

Engineering Specifications Table

OEM Part NumberYTX5L-BS
Component NameAGM Battery (12V 4Ah)
Brand / Model FitmentYamaha Vino Classic 50
Dimensions / Sizing114 x 71 x 106 mm
Torque SpecsTerminal screws: Hand tight
Fluid / Electrical SpecsSealed Lead Acid (AGM)
Cross-CompatibilityYamaha Zuma 50, Honda Metropolitan

Installation & Torque Warning

Improper installation of the AGM Battery (12V 4Ah) can lead to severe mechanical failure. Always ensure that the mounting surfaces are clean and free of debris. When tightening fasteners, it is mandatory to use a recently calibrated torque wrench. The manufacturer specifies a torque value of Terminal screws: Hand tight for this component. Over-tightening can strip the threads or warp the housing, while under-tightening may result in excessive vibration and part detachment during operation.

OEM Verification & Reliability

For optimal performance of your Yamaha Vino Classic 50, verify that you are installing a genuine part matching OEM number YTX5L-BS. While aftermarket alternatives might seem cost-effective initially, they frequently suffer from dimensional inaccuracies that compromise the overall system integrity. Genuine parts are manufactured to exact metallurgical and dimensional tolerances designed specifically for your scooter's engine dynamics.

Frequently Asked Questions (FAQ)

1. How often should I inspect the AGM Battery (12V 4Ah) on my Yamaha Vino Classic 50?
Routine inspection intervals depend on your riding conditions, but it is highly recommended to inspect this component during your standard service intervals (usually every 3,000 to 4,000 miles). Look for signs of abnormal wear, heat discoloration, or loss of structural integrity.
2. Can I use a generic replacement instead of the OEM YTX5L-BS?
Using generic or unbranded parts is strongly discouraged by service professionals. The exact dimensions (114 x 71 x 106 mm) and material composition of the genuine component are required to safely handle the operational stresses of the scooter.
3. What is the most common mistake when installing this part?
The most frequent error is ignoring the factory torque specifications. Failing to apply the required Terminal screws: Hand tight disrupts the mechanical equilibrium of the assembly. Always refer to your factory service manual alongside these specifications.